The need for clean water is very important for the community. Clean water must be properly planned so that the water supply in the house runs efficiently. That is why we need a professional pipe fabricatiors for clean water installation system with appropriate, accurate, and efficient water channel to maximize the distribution of clean water for the community. To ensure clean water supply, we need to pay attention to the installation of clean water. Immature planning will only interfere with the smooth distribution of water. These include designing water installation systems using pipelines. There are several things that should be considered in the planning of piped water systems at home. Among them choose the right type of pipes, connection systems, fittings and accessories, as well as the installation model. Here’s a little explanation.

Connection System, Fitting and Accessories

There are two kinds of connection for PVC pipe, that is solvent cement joint and rubber ring joint. For PE pipes more precisely use the type of joint fusion joint (electro fusion, butt fusion, socket fusion) and mechanical joint. Glue types also contain two types: adhesive glue (adhesive / paste, base-based adhesive-based chemicals) and unifying glue (uniting the two joints, based on diluted pipe material).

As a connector, there are many types of fittings. Among them, repair socket, clamp sadle, bend rubber and many more. And as a complement, it takes accessories to set and direct, including ball valve, plug faucet, tusen klap, water meter and various other sanitary products. Flow Solution becomes the right reference source in terms of connection of various pipeline installations.

Installation Model

There are two models of clean water pipe installation at home, ie closed system and open system. Closed system or loop system is a connection system where the end of the last pipe connects again with the end of the initial pipe. This system has a flat water pressure in the water outlet. It takes a lot of pipes to use this system, so it costs more. The open system that both ends of the pipe connect does not connect. Output water at the tip will be low pressure. The advantage is, just use a little pipe, so the cost is cheaper.